Chapter 2. Unpacking
Printer
2-4
DP5000 Series Printers
Moving the Printer
Use the following procedure to move the printer off of the shipping pallet:
1. Cut the straps securing the printing system box to the pallet.
2. Remove the box lid.
3. Remove any loose packing material from inside the printer box.
Note: Manuals, cables, software and other small items are packed inside the
installation kit box. If only a printer and printheads were shipped, these
items will be shipped inside a separate box.
4. Cut open the end of the box next to the umbilical connection.
5. Fold down the cut box wall.
6. Uncoil the umbilical and lay it on top of the printer, or to one side.
7. Make sure the umbilical does not obstruct moving the printer.
Caution: The following steps require two persons.
8. If two persons are available, work together to lift the printer out of its
packing base and set it on a level surface.
9. If only one person is available, pull the printer slowly out of the box
and off the pallet.
Caution: Do not let the printer drop or tip over.
10. Coil the umbilical around the umbilical hanger on the printer rear
panel and nest the printhead housing in the coils.
11. Continue with "System Unpacking".