2. Route the cable with the connector at the printer and the cut ends at
the device to be activated (see Figure 3.18).
Figure 3.18
Connector wiring, relay contact cable
3. Plug the cable into the SORT / STOP connector on the printer back
panel (see Figure 3.19).
!
WARNING
Do not touch the terminals in the cable connector when connecting or
disconnecting the cable. The cable terminals are a high-voltage hazard
when the cable runs from a label base.
Figure 3.19
Sort relay cable connection, printer back panel
4. Power off the device or I/O box being connected.
5. Strip and separate the wires in the cut end of the cable.
6. Connect the brown wire to the terminal for contact 1 (hot).
7. Connect the blue wire to the terminal for contact 2 (neutral).
8. Cap the unused end of the cable.
Chapter 3. Printer Installation
Printer Connections
Installation Guide
3-19