Selector switch
(cover on)
Printer Connections
Figure 3.8
5. Rotate the safety cover counter-clockwise to clear the rotary switch.
a. Use a large, flat-blade screwdriver to turn the switch.
6. Select the correct voltage for the input power source at the installation
site. Six settings are provided (see Figure 3.9); the factory default
setting is 120V. The setting is indicated by the triangle on the rotary
switch.
7. Replace the fuse.
8. Replace and secure the safety cover.
Figure 3.9
120V
Use the procedures in the following sections to install the necessary
printer connections. The type of data connection used depends on the
printing system and printing application. The printer requires the following
connections:
•
Printer power
•
Tach and cue
•
One of three types of data connection:
•
Ethernet
•
Centronics (parallel) and RS 232 (serial)
•
K4K.
Fuse removal, circuit breaker switch
Voltage selector switch, DP5120 and DP5240
Chapter 3. Printer Installation
Printer Connections
Installation Guide
3-9