Table of Contents
Advertisement
S
S
1. Typical Server Installation (one per subnet)
-
For most installations perform the 'typical' installation of the Kodak 1200i software
suite. This is ideal for most environments including those using a single computer
single printer configuration. Note: this software only runs on Windows®
2000/2000/2003 Pro/Server and XP/XP Pro.
NOTE:
Verify another Microsoft SQL database is not loaded or being used by customer
on same subnet – do not load the software suite or conflicts may be encountered.
-
For peer-to-peer connections use an Ethernet crossover cable otherwise use a
regular Ethernet patch cable through a Switch (100FD capable). Configure the
TCP/IP address either through the software installation instructions or directly at
the printer under Setup Menu – Network Menu.
2. Client Installation (one per workstation)
-
Install the Client Installation package onto additional workstations that will be
printing to the printer (in addition to the server workstation). Note: the database
program (MSDE) should only be installed onto the primary server workstation (one
subnet per server).
NOTE:
While the software suite is not required to run the RIP or drive the printer, the NJ1000i
driver will normally need to be loaded for most RIPs to communicate properly with the printer (one
exception is NT 4.0). The primary advantage of loading the printer software is easy setup on the
network, job accounting features,
media feed calibration (best
operational feature!), ink usage
and allowing remote control over
the printer settings. If the software
is not registered the job
accounting elements will become
disabled after 90 plot hours –
perform product registration via
the Client software under Help.
Technical Training Guide
KODAK
o
f
t
w
a
r
e
C
o
f
t
w
a
r
e
C
1200i WIDE-FORMAT PRINTING SYSTEM
o
n
t
r
o
l
T
i
p
o
n
t
r
o
l
T
i
p
s
s
30
Advertisement
Table of Contents
