Note: This switch is on the printer rear panel (see Figure 3.11).
Note: The DP5122 does not have the voltage selector switch.
Note: The standard printer power cord is CORD-JUMPER ACC UL/CSA
Circuit breaker switch
Power cord connector
Printer Power
Use the following procedure to connect the printer power cord.
1. Confirm the circuit breaker switch is in the offline position (O).
2. For a DP5120 or DP5240, check that the voltage selector switch is
set correctly (see "Voltage Selection").
3. Plug the female end of the power cord to the circuit breaker
receptacle on the printer back panel.
<HAR> M/F 10A/250V 8'- 2" (2.5m), part number 0100238-102.
4. Plug the male end of the cord into a compatible power source
receptacle.
In a printing system, this cord is factory installed; it is plugged into a
receptacle in the cabinet power distribution panel.
For specifications on printer power requirements see "Appendix C. Site
Requirements".
Figure 3.11
Power cord connector, printer back panel
Chapter 3. Printer Installation
Printer Connections
Installation Guide
3-11