Chapter 2. Unpacking
Printing System
Box lid
Ramp diagram
Bands
Plastic cover
for ramps
2-6
DP5000 Series Printers
Figure 2.3
7. Remove the box lid.
8. Remove and discard the cut bands.
9. Remove the side walls of the box (see Figure 2.4).
Figure 2.4
Cutouts
10. Remove the plastic cover from the printing system.
11. Remove the packing material from around the base of the printing
system enclosure on the short side of the box next to the two cutouts
in the pallet rim for the ramps.
12. Remove the screws taped to the ramps.
13. Secure the ramps to the pallet with the screws supplied. Use the pre-
drilled holes on the pallet frame at each cutout.
Printing system box, ready for unpacking
Printing system box, side walls removed