Nortel BCM50a Configuration Manual page 301

Table 75 Sample IKE key exchange logs
Log Message
!! Active connection allowed
exceeded
!! IKE Packet Retransmit
!! Failed to send IKE Packet
!! Too many errors! Deleting
SA
!! Phase 1 ID type mismatch
!! Phase 1 ID content
mismatch
!! No known phase 1 ID type
found
Peer ID: IP address type <IP
address>
vs. My Remote <IP address>
vs. My Local <IP address>
-> <symbol>
Error ID Info
Description
The BCM50a Integrated Router limits the number of
simultaneous Phase 2 SA negotiations. The IKE key
exchange process fails if this limit is exceeded.
The BCM50a Integrated Router did not receive a
response from the peer and so retransmits the last
packet sent.
The BCM50a Integrated Router cannot send IKE
packets due to a network error.
The BCM50a Integrated Router deletes an SA when
too many errors occur.
The ID type of an incoming packet does not match
the local's peer ID type.
The ID content of an incoming packet does not
match the local's peer ID content.
The ID type of an incoming packet does not match
any known ID type.
The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays the IP address type and IP address of the
incoming packet.
The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays this router's configured remote IP address
type or IP address that the incoming packet did not
match.
The IP address type or IP address of an incoming
packet does not match the peer IP address type or IP
address configured on the local router. The log
displays the configured local IP address type of the
router or IP address that the incoming packet did not
match.
The router sent a payload type of IKE packet.
The parameters configured for Phase 1 ID content
do not match or the parameters configured for the
Phase 2 ID (IP address of single, range or subnet) do
not match. Check all protocols and settings for these
phases.
BCM50a Integrated Router Configuration — Advanced
Appendix J Log descriptions 301