Figure 92 Menu 24.10 System Maintenance: Time And Date Setting; Table 39 Time And Date Setting Fields - Nortel BCM50a Configuration Manual

182 Chapter 16 System Maintenance menus 8 to 10

Figure 92 Menu 24.10 System Maintenance: Time and Date Setting

Press Space Bar to Toggle.
Table 39

Table 39 Time and Date Setting Fields

Field
Time Protocol
Time Server
Address
Current Time
New Time
N0115791
Menu 24.10 - System Maintenance - Time and Date Setting
Time Protocol= NTP (RFC-1305)
Time Server Address= a.ntp.alphazed.net
Current Time:
New Time (hh:mm:ss):
Current Date:
New Date (yyyy-mm-dd):
Time Zone= GMT
Daylight Saving= No
Start Date (mm-nth-week-hr):
End Date (mm-nth-week-hr):
Press ENTER to Confirm or ESC to Cancel:
describes the fields in
Description
Enter the time service protocol that your time server uses. Not all
time servers support all protocols, so check with your ISP or network
administrator or use trial and error to find a protocol that works. The
main differences between the time protocols are the format.
Daytime (RFC 867) format is the day/month/year/time zone of the
server.
Time (RFC-868) format displays a 4-byte integer giving the total
number of seconds since 1970/1/1 at 0:0:0.
The default, NTP (RFC-1305), is similar to Time (RFC-868).
Select Manual to enter the new time and new date manually.
Enter the IP address or domain name of your timeserver. Check with
your ISP or network administrator if you are unsure of this
information. The default is a.ntp.alphazed.net.
This field displays an updated time only when you reenter this menu.
Enter the new time in hour, minute and second format. This field is
available when you select Manual in the Time Protocol field.
Figure 92.
01 : 07 : 41
N/A N/A N/A
2000 - 01 - 01
N/A N/A N/A
Jan. - 1st - Sat. -
Jan. - 1st - Sat. -
00
00