Ipsec Commands; Table 60 Ipsec Commands - Nortel BCM50a Configuration Manual

IPSec commands

Table 60
be preceded by
IPSec rule, if you have it configured.

Table 60 IPSec commands

Command
debug type
level
display
switch <on|off>
timer
chk_conn.
dpdTime
update_peer
lists and describes the IP Sec commands. Each of these commands must
. For example, type
ipsec
<0:Disable |
1:Original
on|off | 2:IKE
on|off | 3:
IPSec
[SPI]|on|off |
4:XAUTHon|off |
5:CERT on|off |
6: All>
<0:None |
1:User | 2:Low
| 3:High>
<0~255>
<minutes>
<0~255>
BCM50a Integrated Router Configuration — Advanced
Appendix G Command Interpreter 257
ipsec display 3
Description
Turns the trace for IPsec debug
information on or off.
Sets the debug level. The higher the
number, the more detailed.
Shows debugging information, including
type and level.
As long as there is one active IPSec rule,
all packets go into the IPSec process to
check against the SPD. When this switch
is turned on, packets are not be put
through the IPSec process, even if there
are active IPSec rules.
Sets the idle timeout for IPSec
connections. The system disconnects an
IPSec connection with no traffic for the
timeout period. The interval is in minutes
(2 default) and 0 means the connection
never times out.
Sets the idle timeout for IPSec
connections where the BCM50a
Integrated Router is waiting for a
response from the peer.
Sets the autotimer for updating IPSec
rules that use a domain name as the
secure gateway IP address. The interval
is in minutes (30 default) and 0 means it
never updates.
to display the third