Nortel BCM50a Configuration Manual page 248

248 Appendix G Command Interpreter
Table 56 Sys commands
Command
romreset
server
pwderrtm
upnp
active
config
display
firewall
load
reserve
save
m50Enable [yes|no]
socket
filter
netbios
N0115791
access
<telnet|ftp|web|icmp|snmp|
dns> <value>
load
disp
port <telnet|ftp|web|snmp>
<port>
save
secureip <telnet|ftp|
web|icmp|snmp|dns> <ip>
[minute]
[0:no/1:yes]
[0:deny/1:permit]
[0:deny/1:pass]
[0:deny/1:permit]
Description
Restores the factory default
configuration file.
Use these commands to configure
remote server management.
Sets the server access type.
Loads server information.
Displays server information.
Sets the server port.
Saves server information.
Sets server secure IP address.
Sets or displays the password error
blocking timeout value.
Activates or deactivates the saved
UPnP settings.
Allows users to make configuration
changes through UPnP.
Displays UPnP information
Allows UPnP to pass through the
firewall.
Saves UPnP information.
Saves UPnP information.
Turns Nortel's proprietary DHCP
enhancement feature on or off.
Displays the system socket's ID #,
type, control block address (PCB), IP
address and port number of peer
device connected to the socket
(Remote Socket) and task control block
(Owner).