Nortel BCM50a Configuration Manual page 253

Table 59 IP commands
Command
dialin_user
tcp status
telnet
tftp
support
stats
traceroute
xparent join
break
urlfilter
enable
exemptZone
customize
<iface> in [mode]
<iface> out
[mode]
[show|in|out|both
|none]
<host> [port]
<host> [ttl]
[wait] [queries]
<iface1>
[<iface2>]
<iface>
[0:no/1:yes]
display
actionFlags
[type(1-3)][enabl
e/disable]
add [ip1] [ip2]
delete [ip1]
[ip2]
reset
display
BCM50a Integrated Router Configuration — Advanced
Appendix G Command Interpreter 253
Description
Sets the BCM50a Integrated Router to use
the RIP information it receives.
Sets the BCM50a Integrated Router to
broadcast its routing table.
Shows the dial-in user RIP direction.
Displays the TCP statistic counters.
Creates a Telnet connection to the specified
host.
Displays whether or not TFTP is supported.
Displays the TFTP statistics.
Sends ICMP packets to trace the route of a
remote host.
Add iface2 to the iface1's group.
Remove the specified interface from the
ipxparent group.
Enables or disables content filtering.
Displays content filtering exempt zone
information.
Enables or disables content filtering exempt
zone action flags that determine to which IP
addresses content filtering applies.
Sets a range of IP addresses to be in the
exempt zone.
Removes a range of IP addresses from the
exempt zone.
Returns the exempt zone settings to the
previous configuration.
Uses the customize commands to configure
content filtering for trusted Web sites,
forbidden Web sites and keyword blocking.
Displays the content filtering customize action
flags.