Nortel I2004 Ip Phone Options; Voip Server Settings Assignment - Nortel BCM50a Configuration Manual

where:
<interface>
[0|1]
Use this command to set the Nortel BCM50 DHCP to assign VoIP server and VLAN
settings to Nortel's IP Telephone 2004. You must also configure the VoIP server and
VLAN settings assignment, see the
This command sets DHCP option 192.

Nortel i2004 IP phone options

Use these commands to add site-specific options to the DHCP server's offer messages that
it sends to Nortel's i2004 IP telephone.

VoIP server settings assignment

Syntax:
ip dhcp <interface> server voipserver [id: 1|2] [server IP] [port (1~65535)]
[retry count (0~255)]
where:
<interface>
[id: 1|2]
[server IP]
Appendix I Enhanced DHCP option commands 285
Specify an interface on the device. Currently you can use this
command with the LAN interface (enif0).
Use "1" to have the Nortel BCM50 assign VoIP server (DHCP
option 128) and VLAN (DHCP option 191) settings to Nortel's
IP Telephone 2004.
Use "0" to not have the Nortel BCM50 assign VoIP server and
VLAN settings to Nortel's IP Telephone 2004.
"Nortel i2004 IP phone options
Specify an interface on the device. Currently you can use
this command with the LAN interface (enif0).
This identifies whether this configuration is for assigning
information about the first or second VoIP server.
This is the IP address of the VoIP server in dotted decimal
format.
BCM50a Integrated Router Configuration — Advanced
section.