Nortel BCM50a Configuration Manual page 258

258 Appendix G Command Interpreter
Table 60 IPSec commands
Command
chk_input
show_runtime sa
spd
updatePeerIp
display <rule index>
policyDisplay <rule index>
dial <rule index>
route lan
wan
load <rule index>
save
config
name
active
negotiationMode
natTraversal
p1MultiPro
N0115791
Description
Adjusts autotimer to check if any inbound
<0~255>
IPsec traffic has passed during the
specified period. If not, the BCM50a
Integrated Router disconnects the tunnel.
Displays runtime phase 1 and phase 2
SA information.
When a dynamic rule accepts a request
and a tunnel is established, a runtime
SPD is created according to the peer's
local IP address. This command displays
these runtime SPDs.
Forces the system to immediately update
IPSec rules that use a domain name as
the secure gateway IP address.
Displays the specified IPSec rule.
Displays the specified IPSec rule's IP
policies.
Triggers the specified phase two
<policy index>
connection.
After IPSec processes a packet and
<on|off>
sends it to the LAN side, this switch
controls whether or not IPSec can be
applied to the packet again.
After IPSec processes a packet and
<on|off>
sends it to the WAN side, this switch
controls whether or not IPSec can be
applied to the packet again.
Edit an IPSec branch office rule with the
specified rule number.
Saves the IPSec branch office rule.
Uses these commands to configure the
IPSec rule.
Sets the name of the rule.
<name>
Turns the rule on or off.
<Yes|No>
Sets the negotiation mode.
<0:Main |
1:Aggressive>
Turns NAT traversal on or off.
<Yes|No>
Turns phase 1 multiple proposal on or off.
<Yes|No>