IBM H Series Installation And Service Manual page 415

ripo: send "AT&FQ T\r"
ignore " \r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATE T\r"
expect " \r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQ V X T\r"
expect " \r" timeout 2
send "ATS = \r"
expect " \r" timeout 2
send "AT&C1&D2\r"
expect " \r" timeout 2
done
error:
expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r"
delay 2
done
# Reset to factory defaults.
# Initialize modem: Echo OFF,
# Limit response codes.
# Confirm commands successful.
# Set AutoAnswer OFF
# Confirm command successful.
# Detect carrier and DTR.
# Confirm command successful.
# RI Power On enabled.
# Handle unexpected modem
# responses.
Appendix E. Modem Configurations
E-21