IBM H Series Installation And Service Manual page 133

Table 3-1 (Page 24 of 40). Firmware Error Codes.
Error Code Description
2BA00371 Service Processor reports Locked
CEC Fan #1
2BA00372 Service Processor reports Locked
CEC Fan #2
2BA00373 Service Processor reports Locked
CEC Fan #3
2BA00374 Service Processor reports power
supply #1 and DASD Fans failed
2BA00375 Service Processor reports power
supply #2 and DASD Fans failed
2BA00376 Service Processor reports power
supply failure
2BA00399 Service Processor reports Unsup-
ported value in EPOW
40100005 A loss of system power detected
40100007 Immediate shutdown
40110000 Redundant power supply fail
40110001 Power supply fail
40110002 Voltage is present, but not detected
on both processor cards
Action / Possible Failing FRU
1. Remove obstruction from CEC Fan 1.
2. Replace CEC Fan 1.
3. If problem persists, replace power
supply.
4. Replace I/O Board (See notes on 3-1.)
1. Remove obstruction from CEC Fan 2.
2. Replace CEC Fan 2.
3. If problem persists, replace power
supply.
4. Replace I/O Board (See notes on 3-1.)
1. Remove obstruction from CEC Fan 3.
2. Replace CEC Fan 3.
3. If problem persists, replace power
supply.
4. Replace I/O Board (See notes on 3-1.)
1. Replace power supply #1 and Failing
DASD Fans.
2. Replace I/O Board (See notes on 3-1.)
1. Replace power supply #2 and Failing
DASD Fans.
2. Replace I/O Board (See notes on 3-1.)
1. Replace failing power supply.
2. Replace I/O Board (See notes on 3-1.)
Replace I/O Board (See notes on 3-1.)
Possible main power loss. If not, replace
power supply.
Possible main power loss. If not, replace
power supply.
1. Power supply.
2. I/O board (See notes on 3-1.)
3. Service Processor (Model H50 only).
1. Power supply.
2. I/O board. (See notes on 3-1.)
3. Service Processor (Model H50 only).
For Model H50:
1. Check cable between CPU card and
PDB for proper seating.
2. Replace power supply.
3. Replace PDB.
For Model H70: Replace power supply.
Chapter 3. Error Code to FRU Index
3-25