IBM H Series Installation And Service Manual page 157

Model H70 Service Processor Checkpoints
Service Processor checkpoints are in the range E010 to E0FF. The message OK
indicates successful service processor testing and initialization. Firmware checkpoints
are listed in "Firmware Checkpoints" on page 3-52.
Note: Go to "MAP 1540: Minimum Configuration" on page 2-37 for any of the fol-
lowing conditions:
A four-digit code in the range of E001 through EFFF displays on the operator
panel but is not listed in the checkpoint table.
A four-digit code displays in the checkpoint table, but does not contain a repair
action or FRU listing.
All of the FRUs listed in the repair action have been replaced and the problem
has not been corrected.
If you replace FRUs and the problem is corrected, go to MAP 410: Repair Checkout
in the Diagnostic Information for Multiple Bus Systems.
Table 3-7 (Page 1 of 3). Model H70 Service Processor Checkpoints
Checkpoint Description
E000 System Support Controller begins
operation. This is an informational
checkpoint.
E010 Starting service processor self-tests
E011 service processor self-tests com-
pleted successfully
E012 Begin to set up Service Processor
helps
E020 Configuring CMOS
E021 Configuring NVRAM
E030 Beginning to build I
E031 Finished building I
E040 Starting serial port tests
E042 Configuring serial port 1
E043 Configuring serial port 2
Action/
Possible Failing FRU
See the note on 3-49.
I/O board. (See notes on 3-1.)
NA
I/O board. (See notes on 3-1.)
I/O board. (See notes on 3-1.)
I/O board. (See notes on 3-1.)
2 C resources. 1. CPU Card.
2. I/O board. (See notes on 3-1.)
3. FMC Card.
2 C resources. 1. CPU Card.
2. I/O board. (See notes on 3-1.)
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
Chapter 3. Error Code to FRU Index
3-49