IBM H Series Installation And Service Manual page 141

Table 3-1 (Page 32 of 40). Firmware Error Codes.
Error Code Description
40D00101 Bist on I/O board failed
40D00102 BIST on system board fail
45800000 Memory controller checkstop
45B00001 A non-compatible memory card is
detected
45C00000 Memory checkstop. (Uncorrectable
memory error.)
48800909 System vpd error
4880090A Generic vpd error
4880090B Error identifying system type using
vpd
4880090C Jtag unable to confirm system type
using system vpd
Action / Possible Failing FRU
I/O board (See notes on 3-1.)
System board.
1. System board.
2. If problem is not resolved continue to
"Step 1540-25" on page 2-61.
Replace the memory card, as indicated by
the physical location code, with a compat-
ible memory card supported by this
system.
1. Attempt to reboot the system in
Service Mode. This preserves the AIX
error log. If the reboot fails, attempt to
reboot from the CD-ROM. If the reboot
is successful, run Diagnostics in
Problem Determination mode to deter-
mine the cause of the failure.
2. System board.
1. Check cable to op-panel
2. Replace op-panel
3. I/O board (See notes on 3-1.)
Refer to "Step 1540-25" on page 2-61.
1. I 2 C bus error.
2. Call for support.
1. Remove cards.
2. Verify part numbers.
3. Install valid cards.
4. Call for support.
Chapter 3. Error Code to FRU Index
3-33