IBM H Series Installation And Service Manual page 299

3. If there are any external cables attached to the adapter, disconnect them.
4. Loosen and remove the screw on top of the adapter's bracket.
5. If there are any internal cables attached to the adapter, disconnect them.
6. Carefully pull the adapter out of the slot.
7. If you are installing another adapter in this expansion slot, follow the instructions
given under "Replacement" on page 7-46.
8. If you are not installing another adapter in this expansion slot, replace the
expansion-slot cover:
a. Slide the cover over the open expansion slot.
b. Tighten the expansion-slot screw on the top of the expansion-slot cover.
H70
1P 2P 3P 4P 5P 6P 7P 8P 1P 2P 3P 4P 5P 6P 7P 8P
Chapter 7. Removal and Replacement Procedures
7-45