IBM H Series Installation And Service Manual page 148

Table 3-1 (Page 39 of 40). Firmware Error Codes.
Error Code Description
D D D 4BA00831 Bad Service Processor image
D
D
D
D
D
D
D
D
D
D
D
D
4BA00832 Error while doing flash update
4BA10001 SSC sram fail
4BA10002 SSC sram fail
4BA10003 Service Processor Fail
4BA10004 Service Processor Firmware Fail
4BA10005 I C Path Fail.
4BA80013 NVRAM
4BA80014 NVRAM (crc) checksum fail.
3-40
RS/6000 Enterprise Server Model H Series Installation and Service Guide
Action / Possible Failing FRU
1. Insert a new DOS-formatted diskette
containing the service processor
firmware update into the diskette
drive. The firmware image must be
named spflash.img.
Note: Insert the diskette only after
checkpoint E080 displays.
2. Cycle ac power and retry the flash
recovery.
3. Cycle the ac power again with another
new diskette and retry the flash
recovery.
4. Replace the I/O board.
1. Re-power the system; re-try the flash
programming a few times.
2. Replace I/O board (See notes on
3-1.)
Refer to "MAP 1540: Minimum
Configuration" on page 2-37.
Refer to "MAP 1540: Minimum
Configuration" on page 2-37.
For Model H50: Replace Service
Processor.
For Model H70: Replace I/O board.
Restore or update the service processor
Flash EPROM.
1. I/O board (See notes on 3-1.)
2. Remove processor card in processor
card connector #2 (if installed) and
see if the problem is resolved. If
problem is resolved replace processor
card. If not, continue.
3. Exchange processor card in processor
card connector #1 with the processor
card removed in step 2 (or replace
processor card if only one processor
card exists) and see if problem is
resolved. If problem is resolved
replace processor card. If not, con-
tinue.
4. System board.
Refer to "MAP 1540: Minimum
Configuration" on page 2-37..
Recoverable temporary condition, unless
succeeded by 4BA80015.