IBM H Series Installation And Service Manual page 126

Table 3-1 (Page 17 of 40). Firmware Error Codes.
Error Code Description
2BA00041 Service processor VPD is corrupted
2BA00050 Service processor reports system
operator panel VPD module not
present or not recognizeable
2BA00051 System operator panel VPD data
corrupted
2BA00060 Service processor reports I/O board
VPD module not present
2BA00061 Service processor reports I/O board
VPD data corrupted
2BA00062 Service processor reports system
board VPD module not present
2BA00063 Service processor reports system
board VPD data corrupted
2BA00064 Service processor reports PCI riser
card VPD module not present
2BA00065 Service processor reports PCI riser
card VPD data corrupted
2BA00066 Service processor reports PCI
expansion card VPD module not
present
2BA00067 Service processor reports PCI
expansion card VPD data corrupted
2BA00070 Service processor reports CPU card
VPD module not present
3-18
RS/6000 Enterprise Server Model H Series Installation and Service Guide
Action / Possible Failing FRU
1. Use the service processor firmware
diskette to re-program the service
processor firmware.
2. Replace the service processor card
(Model H50 only).
Replace the operator panel control
assembly. (See notes on 3-1.)
Note: Swap the old VPD module from
the old operator panel control assembly to
the new one.
Replace the operator panel control
assembly. (See notes on 3-1.)
Note: Swap the old VPD module from
the old operator panel control assembly to
the new one.
Replace the I/O board (See notes on
3-1.)
Replace the I/O board (See notes on
3-1.)
Replace the system board.
Replace the system board.
Replace the PCI riser card.
Replace the PCI riser card.
Replace the PCI expansion card.
Replace the PCI expansion card.
1. Remove processor card in processor
card connector #2 (if installed) and
see if the problem is resolved. If
problem is resolved replace processor
card. If not, continue.
2. Exchange processor card in processor
card connector #1 with the processor
card removed in step 1 (or replace
processor card if only one processor
card exists) and see if problem is
resolved. If problem is resolved
replace processor card.