IBM H Series Installation And Service Manual page 125

Table 3-1 (Page 16 of 40). Firmware Error Codes.
Error Code Description
2BA00000 Service processor POST failure
2BA00012 Service processor reports self-test
failure
2BA00013 Service processor reports bad
NVRAM CRC
2BA00014 Service processor reports bad
service processor firmware
2BA00017 Service processor reports bad or
low battery
2BA00018 EPOW test failure
2BA00019 IRQ13 test failure
2BA00024 Service processor reports bad
Power Controller firmware
2BA00040 Service processor reports Service
Processor VPD module not present
Action / Possible Failing FRU
1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel is
blank.
2. Plug the system power cable back in
and retry the operation.
3. Replace the service processor card
(Model H50 only).
4. Replace the I/O board. (See notes on
3-1.)
1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel is
blank.
2. Plug the system power cable back in
and retry the operation.
3. Replace the service processor card
(Model H50 only).
4. Replace the I/O board (See notes on
3-1.)
1. If problem persists, replace battery.
2. Replace the I/O board (See notes on
3-1.)
Use service processor firmware diskette to
re-program firmware.
1. Replace the battery.
2. Replace the service processor card
(Model H50 only).
3. Replace the I/O board (See notes on
3-1.)
1. Replace the service processor (Model
H50 only).
2. Replace the I/O board (See notes on
3-1.)
1. Replace the I/O board (See notes on
3-1.)
2. Replace the service processor card
(Model H50 only).
Use the System Firmware diskette to re-
program the System firmware.
1. Use the Service Processor Firmware
diskette to re-program the Service
Processor firmware.
2. Replace the Service Processor card
(Model H50 only).
Chapter 3. Error Code to FRU Index
3-17