IBM H Series Installation And Service Manual page 123

Table 3-1 (Page 14 of 40). Firmware Error Codes.
Error Code Description
28030003 RTC initialization required. RTC not
updating, not corrected.
28030004 RTC operating parameters (data
format) changed.
28030005 RTC battery error.
28030006 Processor frequency measurement
error.
29000002 Keyboard/Mouse controller failed
self-test
29A00003 Keyboard not present/detected
29A00004 Keyboard stuck key test failed
29B00004 Mouse not present/detected
2B284A00 Illegal condition detected
2B200402 Unsupported Processor
2B2xxx11 Processor manually deconfigured
(H70 only)
Action / Possible Failing FRU
Replace the I/O board (See notes on 3-1.)
1. Set/restore the time and date.
2. Refer to Action under error code
28030xxx.
1. Replace the battery.
Note: Password, Time, and Date
must be reset.
2. Refer to Action under error code
28030xxx.
Replace the I/O board (See notes on 3-1.)
Note: Replacing the battery does not
correct this error condition.
Replace the I/O board (See notes on 3-1.)
1. Keyboard
2. Replace the I/O board (See notes on
3-1.)
1. Keyboard
2. Replace the I/O board (See notes on
3-1.)
1. Mouse
2. Replace the I/O board (See notes on
3-1.)
Contact your next level of support. Do not
replace any FRUs in an attempt to fix this
problem.
CPU card.
Go to Service Processor Menus and man-
ually reconfigure processors.
Use Option 3 System Information.
Use O\tion 8 to reconfigure
processors.
See error code 2B2xxx22 for descripion of
processor type.
Chapter 3. Error Code to FRU Index
3-15