IBM H Series Installation And Service Manual page 155

Table 3-6 (Page 3 of 4). Model H50 Service Processor Checkpoints
Checkpoint Description
E075 Entering SP menus
E076 Leaving SP menus; attempting to
disconnect modems
E0A0 Beginning Bring-Up Phase
E0B0 Starting CPU BIST
E0C0 Starting X5 BIST
E0D0 Creating JTAG scanlog (failure diag-
nostic information)
E0E0 Pulling CPU out of reset
E0E1 Pull CPU out of reset: okay
Action/
Possible Failing FRU
1. Service Processor (Model H50
only).
2. I/O board. (See notes on 3-1.)
3. CPU Card.
1. Service Processor (Model H50
only).
2. I/O board. (See notes on 3-1.)
3. CPU Card.
1. Service Processor (Model H50
only).
2. I/O board. (See notes on 3-1.)
3. CPU Card.
1. CPU Card.
2. I/O board. (See notes on 3-1.)
3. Service Processor (Model H50
only).
1. CPU Card.
2. I/O board. (See notes on 3-1.)
3. Service Processor (Model H50
only).
N/A--wait for completion
1. CPU Card.
2. I/O board. (See notes on 3-1.)
3. Service Processor (Model H50
only).
1. Remove processor card in slot
2 (if installed) and see if the
problem is resolved. If problem
is resolved replace processor
card. If not continue.
2. Exchange processor card in slot
1 with the processor card
removed in step 1 (or
replaceprocessor card if only
one processor card exists) and
see if problem is resolved. If
problem is resolved replace
processor card. If not continue.
3. System board.
4. I/O board. (See notes on 3-1.)
5. Service Processor (Model H50
only).
Chapter 3. Error Code to FRU Index
3-47