IBM H Series Installation And Service Manual page 40

1. Insert the diagnostic CD-ROM into the CD-ROM drive.
2. Turn the power off.
3. Turn the power on.
4. When the keyboard indicator is displayed (the word keyboard on an ASCII ter-
minal or the keyboard icon on a graphical display), press the F5 key on the
directly-attached keyboard or the number 5 key on an ASCII terminal.
5. Enter any requested passwords.
6. Wait until the diagnostics are loaded or the system appears to stop.
7. Find your symptom in the following table; then follow the instructions given in the
Action column.
Symptom
The diskette LED is blinking rapidly, or EIEA or
EIEB is displayed on the operator panel.
The system stops with a prompt to enter a pass-
word.
The diagnostic operating instructions are dis-
played.
The system login prompt is displayed.
The system does not respond when the pass-
word is entered.
2-6
RS/6000 Enterprise Server Model H Series Installation and Service Guide
Action
The flash EPROM data is corrupted. The
recovery procedure for the flash EPROM should
be executed. See "System Firmware Recovery"
on page 6-24.
Enter the password. You are not allowed to con-
tinue until a correct password has been entered.
When you have entered a valid password go to
the beginning of this table and wait for one of
the other conditions to occur.
Go to MAP 0020 in the Diagnostic Information
for Multiple Bus Systems.
You may not have pressed the correct key or
you may not have pressed the key soon enough
when you were to indicate a Service Mode IPL
of the diagnostic programs. If this was the case
start over at the beginning of this Step.
Note: Perform the systems shutdown proce-
dure before turning off the system.
If you are sure you pressed the correct key in a
timely manner, go to "Step 1020-2" on
page 2-8.
Go to "Step 1020-2" on page 2-8.