Setting Originals In The Document Feeder - Ricoh FT7950 Operating Instructions Manual

COPYING
Setting Originals In the
Document Feeder
Note
The last page should be on the bottom.
If there are more originals than that can be
set at a time, divide the originals into sev-
eral blocks and set the blocks sequentially
starting at the last block.
Do not stack originals beyond the limit
mark on the side fence of the document
feeder.
When copying thin originals (41 - 52 g/
2
m , 11-14lb), set one original at a time in
the document feeder or exposure glass. See
⇒ P.25 "Thin Paper."
The original might become dirty if it is writ-
ten with a pencil or similar tools.
Reference
Regarding originals that the document feeder
can handle, see ⇒ P.11 "ORIGINALS."
Setting a stack of originals in the
document feeder
1
Adjust the guide to the original size.
2
Set the aligned originals face up into the
document feeder.
22
Note
To avoid a multi-sheet feed, shuffle the
originals before setting them in the docu-
ment feeder.
Setting One Original At A Time
(SADF)mode
1
Set one original and press the {Start}
key.
2
Set the next original while the Feed in-
dicator is lit.
The second and subsequent originals can
be fed automatically without pressing the
{Start} key.
Note
You can adjust the time the machine waits
before being ready for the next original.
See ⇒ P.97 "SADF Auto reset."