Table of Contents
Advertisement
Quality of Service
Applying Rate Limit Profiles to Interfaces
STEP 4
Applying Rate Limit Profiles to Interfaces
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
•
CIR—Specify the committed information rate, which is the rate at which data
is transmitted. The rate is averaged over a minimum time increment. The
range is 64-1048576 Kbps.
•
CBS—Specify a committed burst size, which is the guaranteed amount of
bandwidth for bursty traffic on the port. The range is 4-16384 KB.
Click Apply and then click Close. Your changes are saved to the Running
Configuration.
If you have created one or more rate limit profiles, you can use this page to assign
them to interfaces. See
profiles.
To apply a rate limit profile to an interface.
Click Quality of Service > Interface Rate Limit in the navigation window.
Use the Interface Type list to display ports or LAGs in the Interface Rate Limit
Table.
Select the interface to configure and click Edit.
Add or remove a profile:
•
To assign a profile to this interface, click the profile ID in the Available list,
and then click the right-arrow button to move it to the Selected list. All
profiles disappear from the Available list, since only one profile can be
assigned to a port.
•
To remove a profile, click the profile ID in the Selected list, and then click the
left-arrow button to move it to the Available list. All profiles appear in the
Selected list.
Click Apply and then click Close. Your changes are saved to the Running
Configuration.
Defining Rate Limit Profiles
12
for instructions on creating
160
Advertisement
Table of Contents
