Logging Out - Cisco SG200 Series Administration Manual

Getting Started
Quick Start Device Configuration
!
CAUTION
Quick Start Device Configuration
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide

Logging Out

By default, the application automatically logs you out after 10 minutes of inactivity.
See Configuring the Idle Session Timeout
default timeout period.
To log out at any time, click Logout in the top right corner of any page.
Unless the Running Configuration is copied to the Startup Configuration file type,
all changes made since the last time the file type was saved are lost if the switch is
rebooted. We recommend that you save the Running Configuration to the Startup
Configuration file type before logging off to preserve any changes you made
during this session.
A red X icon displayed to the left of the Save button indicates that Running
Configuration changes have been made that have not yet been saved to the Startup
Configuration file type.
When you click Save, the page displays (see
Configuration and Log
Startup Configuration file type. After this save, the red X icon and the Save button
no longer display.
To simplify device configuration through quick navigation, the Getting Started
page provides links to the most commonly-used pages.
Links on the Getting Started Page
Category Link Name (on the Page)
Initial Setup Change Device IP Address
Create VLAN
Configure Port Settings
for instructions on changing the
Files). Save the Running Configuration by copying it to the
Downloading and Backing Up the
Linked Page
IPv4 Interface
Create VLAN
Port Settings
2
10