Table of Contents
Advertisement
Port Management
Link Aggregation
STEP 3
STEP 1
STEP 2
STEP 3
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
•
Port List/LAG Member—To add or remove ports from a static LAG, select
each port and click the left or right arrow to move it between the Port and
LAG Member lists.
Click Apply and then click Close. Your changes are saved to the Running
Configuration.
Configuring LAG Settings
You can use the LAG Settings page to administratively enable or disable a LAG
and configure load balancing settings.
To configure LAG settings:
Click Port Management > Link Aggregation > LAG Settings in the navigation
window.
The LAG Settings Table lists each available LAG.
Select a LAG to configure, and then click Edit.
Specify the following for the selected LAG:
•
Administrative Status—Select Up or Down to administratively enable or
disable the LAG. When a LAG is disabled, its member ports operate as
standalone physical ports.
•
Load Balance Algorithm—Select one of the options to enable the switch to
load-balance outgoing packets among member ports of a LAG. The switch
selects one of the links in the channel for transmitting specific packets. The
switch prioritizes each criteria for load balancing in the order listed in the
option. The options are:
-
Src/Dest MAC, VLAN, EType, incoming port—Source and destination
MAC addresses, the VLAN membership, the Ethertype field, and the port
on which the packet was received.
-
Src/Dest IP and TCP/UDP Port Fields—Src IP—Source and destination
IP address and the TCP or UDP port number in the IP packet.
If the IP packet option is selected, non-IP packets received on the port are
balanced using the Src and Dest MAC address.
•
MTU—Specify the maximum transmission unit size in bytes. The default
MTU is 1518 and the range is between 1518 and 9216 bytes.
5
84
Advertisement
Table of Contents
