Table of Contents
Advertisement
VLAN Management
Configuring VLAN Membership
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
•
If the switch receives an tagged frame from a VLAN, the switch will remove
the VLAN tag before forwarding the frame to the egress ports that are
configured as untagged members of the VLAN.
•
If the switch receives an tagged frame from a VLAN, the switch will forward
the frame as is to egress ports that are configured as tagged members of
the VLAN.
Configuring Port to VLAN
To use the Port to VLAN page to assign ports to VLANs.
Click VLAN Management > Port to VLAN in the navigation window.
For the selected VLAN ID and port/LAG, this page displays the administrative
configuration of the interface port mode (access, trunk, and general), membership,
tagging option, and PVID of every port with respect to the VLAN. (See
VLAN Interface Settings
Select the VLAN ID to configure and use the Interface Type list to display either
ports or LAGs.
For each interface, configure the following parameters:
•
Member—Check this box if a port is to be member of the VLAN. Uncheck
this box if a port is not to be member of the VLAN. A port is not member of
the VLAN by default.
•
Tagged—Select Tagged if all the packets of the VLAN egress to the port are
to be tagged. Otherwise, select Untagged. A trunk port is tagged by default.
This option is only relevant if the port is a member of the VLAN.
•
Untagged—Select Untagged if the packets from the VLAN egress to the
port are to be untagged. Otherwise, select Tagged. An access port is always
untagged. An general port is untagged by default. This option is relevant only
if the port is a member of the VLAN.
•
PVID—Check this box if a port is to use the selected VLAN ID as its port
VLAN ID (PVID). Otherwise, uncheck this box. If PVID is selected for an
access or trunk port, the port must be an untagged member of the VLAN.
Untagged packets received from the port will be assigned to the
corresponding VLAN.
Click Apply. Your changes are saved to the Running Configuration.
for instructions on configuring this setting.)
6
Configuring
100
Advertisement
Table of Contents
