Table of Contents
Advertisement
VLAN Management
Configuring VLAN Interface Settings
STEP 3
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
-
User defined—The VLAN ID you specify is used as the untagged VLAN
membership for the Trunk port. The PVID for the port is also set to the
specified VLAN ID.
•
Access VLAN—(Access ports only) An access port can be a member of set
only to the Access VLAN ID.
•
Frame Type—Specifies the frame type accepted on the port:
-
Admit Untagged Only—Only untagged frames are accepted on the port.
Tagged frames are discarded.
-
Admit Tagged Only—Only tagged frames are accepted on the port.
Untagged frames are discarded.
-
Admit All—Both tagged and untagged frames are accepted on the port.
An access port can admit untagged frames only. A trunk port can be a
member of at most one untagged VLAN and one or more tagged VLANs. If a
trunk port is member of both untagged and tagged VLANs, it admits all frame
types. If the trunk port is member of tagged VLANs only, it admits tagged
frames only.
•
Ingress Filtering—Select to enable ingress filtering on the port. When
ingress filtering is enabled, the switch accepts frames only from the VLANs
of which it is a member. It discards frames received from other VLANs. All
ports in access or trunk mode will always have their Ingress Filtering
enabled. Disabling and enabling Ingress Filtering is only available on ports
set to General Mode.
•
VLAN Priority—The default 802. 1 p priority value for the port. The value will
be applied to the incoming packets based on the QoS trust mode configured
at the port and the types of the packets. See
and instructions on configuring the port trust mode.
Click Apply and then click Close. Your changes are saved to the Running
Configuration.
QoS Properties
for information
6
97
Advertisement
Table of Contents
