Applying Igmp Profiles (Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring IGMP
Command or Action
Step 8
show running-config
Example:
Device# show running-config
Step 9 copy running-config startup-config
Example:
Device# copy running-config
startup-config

Applying IGMP Profiles (CLI)

To control access as defined in an IGMP profile, you have to apply the profile to the appropriate interfaces.
You can apply IGMP profiles only to Layer 2 access ports; you cannot apply IGMP profiles to routed ports
or SVIs. You cannot apply profiles to ports that belong to an EtherChannel port group. You can apply a profile
to multiple interfaces, but each interface can have only one profile applied to it.
Follow these steps to apply an IGMP profile to a switch port:
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ip igmp filter profile number
5. end
6. show running-config
7. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
OL-32598-01
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
Applying IGMP Profiles (CLI)
61