Configuring Ip Addressing; Default Addressing Configuration - Cisco Catalyst 3750-X Software Configuration Manual

Configuring IP Addressing

Configuring IP Addressing
A required task for configuring IP routing is to assign IP addresses to Layer 3 network interfaces to
enable the interfaces and allow communication with the hosts on those interfaces that use IP. These
sections describe how to configure various IP addressing features. Assigning IP addresses to the
interface is required; the other procedures are optional.
•
•
•
•
•
•

Default Addressing Configuration

Table 42-1 Default Addressing Configuration
Feature
IP address
ARP
IP broadcast address
IP classless routing
IP default gateway
IP directed broadcast
IP domain
IP forward-protocol
IP helper address
IP host
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
42-6
Default Addressing Configuration, page 42-6
Assigning IP Addresses to Network Interfaces, page 42-7
Configuring Address Resolution Methods, page 42-9
Routing Assistance When IP Routing is Disabled, page 42-12
Configuring Broadcast Packet Handling, page 42-14
Monitoring and Maintaining IP Addressing, page 42-18
Default Setting
None defined.
No permanent entries in the Address Resolution Protocol (ARP) cache.
Encapsulation: Standard Ethernet-style ARP.
Timeout: 14400 seconds (4 hours).
255.255.255.255 (all ones).
Enabled.
Disabled.
Disabled (all IP directed broadcasts are dropped).
Domain list: No domain names defined.
Domain lookup: Enabled.
Domain name: Enabled.
If a helper address is defined or User Datagram Protocol (UDP) flooding is configured, UDP
forwarding is enabled on default ports.
Any-local-broadcast: Disabled.
Spanning Tree Protocol (STP): Disabled.
Turbo-flood: Disabled.
Disabled.
Disabled.
Chapter 42 Configuring IP Unicast Routing
OL-21521-01