Cisco Catalyst 3750-X Software Configuration Manual page 1059

Chapter 42 Configuring IP Unicast Routing
Command
neighbor {ip-address | peer-group-name}
Step 7
default-originate [route-map map-name]
neighbor {ip-address | peer-group-name}
Step 8
send-community
neighbor {ip-address | peer-group-name}
Step 9
update-source interface
neighbor {ip-address | peer-group-name}
Step 10
ebgp-multihop
neighbor {ip-address | peer-group-name}
Step 11
local-as number
neighbor {ip-address | peer-group-name}
Step 12
advertisement-interval seconds
neighbor {ip-address | peer-group-name}
Step 13
maximum-prefix maximum [threshold]
neighbor {ip-address | peer-group-name}
Step 14
next-hop-self
neighbor {ip-address | peer-group-name}
Step 15
password string
neighbor {ip-address | peer-group-name}
Step 16
route-map map-name {in | out}
neighbor {ip-address | peer-group-name}
Step 17
send-community
neighbor {ip-address | peer-group-name} timers
Step 18
keepalive holdtime
neighbor {ip-address | peer-group-name} weight
Step 19
weight
neighbor {ip-address | peer-group-name}
Step 20
distribute-list {access-list-number | name} {in |
out}
neighbor {ip-address | peer-group-name}
Step 21
filter-list access-list-number {in | out | weight
weight}
neighbor {ip-address | peer-group-name}
Step 22
version value
OL-21521-01
Purpose
(Optional) Allow a BGP speaker (the local router) to send the
default route 0.0.0.0 to a neighbor for use as a default route.
(Optional) Specify that the COMMUNITIES attribute be sent to
the neighbor at this IP address.
(Optional) Allow internal BGP sessions to use any operational
interface for TCP connections.
(Optional) Allow BGP sessions, even when the neighbor is not
on a directly connected segment. The multihop session is not
established if the only route to the multihop peer's address is the
default route (0.0.0.0).
(Optional) Specify an AS number to use as the local AS. The
range is 1 to 65535.
(Optional) Set the minimum interval between sending BGP
routing updates.
(Optional) Control how many prefixes can be received from a
neighbor. The range is 1 to 4294967295. The threshold
(optional) is the percentage of maximum at which a warning
message is generated. The default is 75 percent.
(Optional) Disable next-hop processing on the BGP updates to a
neighbor.
(Optional) Set MD5 authentication on a TCP connection to a
BGP peer. The same password must be configured on both BGP
peers, or the connection between them is not made.
(Optional) Apply a route map to incoming or outgoing routes.
(Optional) Specify that the COMMUNITIES attribute be sent to
the neighbor at this IP address.
(Optional) Set timers for the neighbor or peer group.
The keepalive interval is the time within which keepalive
•
messages are sent to peers. The range is 1 to 4294967295
seconds; the default is 60.
The holdtime is the interval after which a peer is declared
•
inactive after not receiving a keepalive message from it. The
range is 1 to 4294967295 seconds; the default is 180.
(Optional) Specify a weight for all routes from a neighbor.
(Optional) Filter BGP routing updates to or from neighbors, as
specified in an access list.
(Optional) Establish a BGP filter.
(Optional) Specify the BGP version to use when communicating
with a neighbor.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring BGP
42-59