Debug Platform Dot1X - Cisco Catalyst 3030 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3030 Debug Commands

debug platform dot1x

Use the debug platform dot1x privileged EXEC command to enable debugging of IEEE 802.1x events.
Use the no form of this command to disable debugging.
Syntax Description initialization
interface-configuration
rpc
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)SEE
Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.
Related Commands Command
show debugging
78-17262-01
debug platform dot1x {initialization | interface-configuration | rpc}
no debug platform dot1x {initialization | interface-configuration | rpc}
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Display IEEE 802.1x-authentication initialization sequence debug
messages.
Display IEEE 802.1x interface configuration-related debug messages.
Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
Cisco Catalyst Blade Switch 3030 Command Reference
debug platform dot1x
B-29