Cisco Catalyst 3030 Command Reference Manual page 125

Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Valid values for port-range type and interface:
•
•
•
When you define a range, you must enter a space between the first entry and the hyphen (-):
interface range gigabitethernet0/1 -2
When you define multiple ranges, you must still enter a space after the first entry and before the
comma (,):
interface range gigabitethernet0/1 - 2, gigabitethernet0/5 - 7
You cannot specify both a macro and an interface range in the same command.
You can also specify a single interface in port-range. The command is then similar to the interface
interface-id global configuration command.
For more information about configuring interface ranges, see the software configuration guide for this
release.
Examples This example shows how to use the interface range command to enter interface-range configuration
mode to apply commands to two ports:
Switch(config)# interface range gigabitethernet0/1 - 2
Switch(config-if-range)#
This example shows how to use a port-range macro macro1 for the same function. The advantage is that
you can reuse macro1 until you delete it.
Switch(config)# define interface-range macro1 gigabitethernet0/1 - 2
Switch(config)# interface range macro macro1
Switch(config-if-range)#
Related Commands Command
define interface-range
show running-config
78-17262-01
vlan vlan-ID, where VLAN ID is from 1 to 4094
gigabitethernet module/{first port} - {last port}, where module is always 0
For physical interfaces:
module is always 0
–
– the range is type 0/number - number (for example, gigabitethernet0/1 - 2)
port-channel port-channel-number - port-channel-number, where port-channel-number is from 1
to 48
When you use the interface range command with port channels, the first and last port
Note
channel number in the range must be active port channels.
Description
Creates an interface range macro.
Displays the configuration information currently running on the switch. For
syntax information, select Cisco IOS Configuration Fundamentals
Command Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
Cisco Catalyst Blade Switch 3030 Command Reference
interface range
2-97