Snmp Trap Mac-Notification - Cisco Catalyst 3030 Command Reference Manual

snmp trap mac-notification

snmp trap mac-notification
Use the snmp trap mac-notification interface configuration command to enable the Simple Network
Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface. Use the
no form of this command to return to the default setting.
Syntax Description added
removed
Defaults
By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History Release
12.2(25)SEE
Usage Guidelines Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification command, the trap is generated only when you enable the snmp-server enable traps
mac-notification and the mac address-table notification global configuration commands.
Examples This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# snmp trap mac-notification added
You can verify your settings by entering the show mac address-table notification interface privileged
EXEC command.
Cisco Catalyst Blade Switch 3030 Command Reference
2-432
snmp trap mac-notification {added | removed}
no snmp trap mac-notification {added | removed}
Enable the MAC notification trap whenever a MAC address is added on this
interface.
Enable the MAC notification trap whenever a MAC address is removed from this
interface.
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
78-17262-01