Cisco Catalyst 3030 Command Reference Manual page 364

show lacp
Table 2-23
Table 2-23
Field
State
LACP Port Priority
Admin Key
Oper Key
Port Number
Port State
Cisco Catalyst Blade Switch 3030 Command Reference
2-336
describes the fields in the display:
show lacp internal Field Descriptions
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Description
State of the specific port. These are the allowed values:
– —Port is in an unknown state.
•
bndl—Port is attached to an aggregator and bundled with
•
other ports.
susp—Port is in a suspended state; it is not attached to any
•
aggregator.
hot-sby—Port is in a hot-standby state.
•
indiv—Port is incapable of bundling with any other port.
•
indep—Port is in an independent state (not bundled but able
•
to switch data traffic. In this case, LACP is not running on
the partner port).
down—Port is down.
•
Port priority setting. LACP uses the port priority to put ports s
in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
Administrative key assigned to this port. LACP automatically
generates an administrative key value as a hexadecimal number.
The administrative key defines the ability of a port to aggregate
with other ports. A port's ability to aggregate with other ports is
determined by the port physical characteristics (for example,
data rate and duplex capability) and configuration restrictions
that you establish.
Runtime operational key that is being used by this port. LACP
automatically generates this value as a hexadecimal number.
Port number.
State variables for the port, encoded as individual bits within a
single octet with these meanings:
bit0: LACP_Activity
•
bit1: LACP_Timeout
•
• bit2: Aggregation
• bit3: Synchronization
bit4: Collecting
•
bit5: Distributing
•
bit6: Defaulted
•
bit7: Expired
•
In the list above, bit7 is the MSB and bit0 is the LSB.
Note
78-17262-01