Queue-Set - Cisco Catalyst 3030 Command Reference Manual

queue-set

queue-set
Use the queue-set interface configuration command to map a port to a queue-set. Use the no form of this
command to return to the default setting.
Syntax Description qset-id
Defaults
The queue-set ID is 1.
Command Modes Interface configuration
Command History Release
12.2(25)SEE
Examples This example shows how to map a port to queue-set 2:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# queue-set 2
You can verify your settings by entering the show mls qos interface [interface-id] buffers privileged
EXEC command.
Related Commands Command
mls qos queue-set output buffers
mls qos queue-set output threshold
show mls qos interface
Cisco Catalyst Blade Switch 3030 Command Reference
2-246
queue-set qset-id
no queue-set qset-id
ID of the queue-set. Each port belongs to a queue-set, which defines all the
characteristics of the four egress queues per port. The range is 1 to 2.
Modification
This command was introduced.
buffers
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
Description
Allocates buffers to a queue-set.
Configures the weighted tail-drop (WTD) thresholds,
guarantees the availability of buffers, and configures the
maximum memory allocation to a queue-set.
Displays quality of service (QoS) information.
78-17262-01