Show Mac Address-Table Notification - Cisco Catalyst 3030 Command Reference Manual

show mac address-table notification

show mac address-table notification
Use the show mac address-table notification user EXEC command to display the MAC address
notification settings for all interfaces or the specified interface.
Syntax Description
interface
interface-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)SEE
Usage Guidelines Use the show mac address-table notification command without any keywords to display whether the
feature is enabled or disabled, the MAC notification interval, the maximum number of entries allowed
in the history table, and the history table contents.
Use the interface keyword to display the flags for all interfaces. If the interface-id is included, only the
flags for that interface appear.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mac address-table notification command:
Switch> show mac address-table notification
MAC Notification Feature is Enabled on the switch
Interval between Notification Traps : 60 secs
Number of MAC Addresses Added : 4
Number of MAC Addresses Removed : 4
Number of Notifications sent to NMS : 3
Maximum Number of entries configured in History Table : 100
Current History Table Length : 3
MAC Notification Traps are Enabled
History Table contents
----------------------
History Index 0, Entry Timestamp 1032254, Despatch Timestamp 1032254
MAC Changed Message :
Cisco Catalyst Blade Switch 3030 Command Reference
2-356
show mac address-table notification [interface [interface-id]] [ | {begin | exclude | include}
expression]
(Optional) Display information for all interfaces. Valid interfaces include
physical ports and port channels.
(Optional) Display information for the specified interface. Valid interfaces
include physical ports and port channels.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3030 Cisco IOS Commands
78-17262-01