Texas Instruments 990 User Manual page 77

Constr uction and Acti vation
When the command LREMSCI is entered, a series of prompts is
displayed on the VDr. For each command required for inclusion in
remote SCI, the user must respond to the corresponding prompt by
accepting the default
YEs.
A NO response to any prompt excludes
the function associ ated wi th the prompt. For example, a NO
response to READ/WRITE CRU will exclude the CRU functions RCRU
and WCRU from the remote SCI program. Attempti ng to use these
functions resul ts in an error message display at the primary
station VDr. When the desired commands have been selected, the
user enters the path name <control> of a file that will store the
link edi t control stream used to link the selected remote SCI
module.
Two successive displays are required to present all options to
the user af ter the command LREMSCI has been entered. In the
following example, all commands listed except MODIFY MEM)RY and
READ/WRITE CRU are accepted.
The first display is as follows:
[] LREMSCI
LINK REM)TE SCI COMMANDS FOR A SEOONDARY
LIST MEMJRY: YES
MODIFY MEMJRY: NO
SHOW TASK STATUS: YES
EXECUTE TASK: YES
KILL TASK: YES
ASSIGJ/RELEASE LUNO: YES
READ/WRITE CRU: NO
After the READ/WRITE CRU prompt is answered, DXlO SCI clears the
screen and di spl ays the second set of prompts as follows:
LINK REMJTE SCI COMMANDS FOR A SEOONDARY
TRACE: YES
BREAKPOINT OOMMANDS: YES
SHOW I/O STATUS: YES
ruMP
~RKSPACE:
YES
DATE AND TIME
(l)
MMA NDS: YE S
INSTALL TASK: YES
RETURN NETIDRK lOS: YES
CONTroL FILE ACCESS NAME: <control>
2270526-9701
3-31