Texas Instruments 990 User Manual page 54

Constr uction and Acti vation
If a value is entered in hexadecimal, it must be preceded by a
zero
(O)
or angle bracket
( » .
3 • 3 • 2 Act i va t i on and Term i na t ion
To activate the network generator, enter the SCI command NETGEN.
This produces the following display:
[] NETGEN
NETIDRK GENE FAT ICN
GENERATE NEW CONFIGURATION (Y/N):
The res};X>nse to this prompt determines the specific group(s) of
prompts that will be displayed next and their sequence. An entry
of Y (yes), followed by a RETURN, starts the sequence of prompts
described in paragraph 3.3.3. An entry of N (no), followed by a
RETURN, starts the sequence described in paragraph 3.3.4.
NETGEN terminates normally after a res};X>nse has been entered to
the DO YOU WAN!' TO SAVE THE OONFIGURATICN prompt as described in
the followi ng paragraphs. To terminate NETGEN at any time, enter
Q
and press RETURN in response to any prompt.
3.3. 3 Generating a New Confi guration
The generation of a new configuration requires the entry of the
following information in res};X>nse to the appropriate prompts:
*
FCCC TIL lNE address
*
Communications device name
*
FCCC channel number
*
Channel data rate (baud rate)
*
Internal/ ext ernal clocki ng requi rement
*
Message retr y requi rement
3-8
2270526-9701