Texas Instruments 990 User Manual page 152

Appl ications U til i ti'es
5 • 4. 3. 3 Del et e Brea kpo i nt (DB) C anm and •
The DB command deletes one or all breakpoints
secondary station or in a specified task.
example resronses for the command are as follows:
i n a s peci fi ed
The prompts and
<>
DB
REM:>TE IELETE BREAKPOINT
SECDNDARY I D: 1021
TASK ID: >4E
ADDRESS: (def aul t)
(example
responses)
The resronses must conform to the followi ng requi rements:
*
SEQ)NDARY ID. Enter the network ID assigned to the
remote SCI tas kin the desi red secondary.
*
TASK ID. Enter the hexadecimal number assigned to the
task at the time of TX5 system generation. If the
default is taken by pressing the RETURN key, or
S
is
entered, any brea kpoi nt address entered is consi dered
absolute.
*
ADDRESS. Enter the address of the brea kpoi nt. If the
default is taken, all breakpoints assigned to the
specified task, or to the system (depending on the
res pons e to the TASK I D prompt) are del et ed •
5.4.3.4 Dunp Workspace (DW) Canmand.
The DW oommand displays the workspace for a
resi dent i n a s peci fi ed s econdar y st ati on •
example resronses for the oommand are as follows:
<>
DW
specified task
The prompts and
REM:>TE
ruMP
W=>RKSPACE
SE<DNDARY I D: 1099
TASK ID: >lA
(e xample
res rons es )
The resronses must conform to the following requirements:
*
SEQ)NDARY ID. Enter the network ID assigned to the
remote SCI task in the desired secondary station.
*
TASK ID. Enter the hexadecimal number assigned to the
t as k at the time of TX5 syst em generation.
5-30 2270526-9701