Texas Instruments 990 User Manual page 201

~pl
ications Utili ti es
*
TASK ID. Enter the network ID of the TX5 task >10.
* MESSAGE CDUNT. Enter the numrer of messages to be sent.
This must
be
in the range of 20 through 50.
*
MESSAGE LENGrH. Enter the length of the message in
byt es (e xcI udi ng over head) •
*
TASK PRIORITY. Enter 1 through 3, depending on the
pr i ori ty requi red. 3 is the
0
XlO def aul t.
* USE ACl'IVATICN SERVICES. Enter YES or NO to indicate
whether activation services are required at the
secondary station.
*
LISTING ACCESS
NAME.
Enter the device or file that is
to recei ve the res ul ts of the ar ti fi ci al dat a test.
If the command AE (Echo Message) was entered, the specified
nunrer of messages, each of the specified length, is sent to the
secondary station and echoed back to the primary station. If the
command AR (Reply to Message) was entered, the specified nunrer
of messages, each of the specified length, is sent to the
secondary station. The secondary station then sends back a one-
byte acknowledgement. If the command AD
(0
rop Message) was
ent ered, t h speci fi ed n urn rer of mess ages, each of the
s peci fi ed
length, is sent. No reply is sent back to the primary station.
Up:>n completion of the test a report in the following format is
sent to the device or file specified as the listing access name:
HOLC MESSAGE TRANSFER INFORMATICN
===
SECDNDARY STATICN ID = NNNN
TEST DURATI(]\J
= ****
SECDNIS
SEND (l)UNT /LENGrH
= *** /* **
REP
LY COUNT /LENGrH
= *** /* **
MESSAGE OUl'PtJr RATE
= **. **
MESSAGES;:SECDND
MESSAGE RESPCNSE TIMES, IN SECDN1l3,
AS
MEASURED AT THE SENDING TASK:
MEAN
= **. **
IDDAL =
**. **
MAXIMJM
= **. **
MINIMUM
=
**. **
LINE SEW ICE TIME/MESSAGE
=
**. **
SECDNIE
LINE
ur
IL
IZ
M'
leN TIME
=
***. **
SECDNIE
WA IT TIME: /ME SS AGE
= **. **
SECDNIS
CLOCK TlME:S - STARr: l4M/DD/HH:MM:SS FINISH: MM/DD/HH:Mf\1:SS
2270526-9701 5-79