Texas Instruments 990 User Manual page 147

Appl ications Utili ti es
*
ERRS. Provides file pathnames for the display of
communication error codes and information.
5.4.3 Remote SCI Canmands
Any command listed in the preceding paragraphs may be executed
after entering the SCI command REMSCI at a DXlO interactive
terminal. To execute a particular oommand, enter the command
name and press the RETURN key. Each command has a set of prompts
to which you must resp::>nd; these are summarized in Table 5-2.
Fur the r det ai I s of the res p::>n s es to rem ot e SCI comm and prom pt s
are pro vi ded below.
*
*
NOTE
Unless otherwise stated, all numbers entered
i
ri
res p::>ns e to a remote SCI prompt can be
entered as a decimal val
ue
or a hexadecimal
val ue. Hexadecimal val ues must be preceded
by a greater than sign
(»
or a zero (0).
SECDNDARY ID. Enter the network ID assigned to the
remote SCI task in the desired secondary station. The
network ID entered for this prompt is the network ID
assi gned when the program is executed.
TASK ID. Enter the hexadecimal number that was assigned
to the t as kin the T
X5
s ys
t em ge ne rat ion.
*
ADDRESS. Enter the address of the word desi red.
*
LUNO. Enter a val id L UNO assi gnment •
*
ACCESS NAME. Enter a valid filename or device name.
*
OBJEcr
FILENAME. Enter the pathname
DX10 obj ect file.
or synonym
*
PRIORITY. Enter a num ber from 0 thro ugh 4.
of a
*
PRIVILEGED. Enter Y (yes )or N (no) to indicate to TX5
whether the task is required to execute as a privileged
or non pr i vi 1 eged t as k •
*
NUMBER OF BYTES. Enter the nunber of bytes to be
accessed or di spl ayed •
2270526-9701 5-25