Texas Instruments 990 User Manual page 228

TX5 System Generation
[] GENTX5
LISTING ACCESS NAME: (NONE)
GENTX5 3.2.0 TX5 SYSGEN
MEMORY AVAILABLE: (2000)
SYSGEN FOR DS990? (NO)
LINE FREQ: (60)
TIME SLICING?(YES)
TIME SLICE VALUE.: (1)
TASK SENTRY? (NO)
COMMON SIZE: (170)
POWER-FAIL RECOVERY? (NO)
#
OF EXP CHASSIS: (0)
DEVICE NAME: LLOl
DEVICE TYPE: SD
TILINE DEVICE? (NO)
CRU BASE ADDR: >20
ACCESS MODE:
INT LEVEL IN MAIN CHASSIS: 4
TIME-OUT COUNT: 2000
CRU !NT BIT: (15)
LABEL OF DSR: HDLCSR
(* Suggested name for the LLM
(* >20 required for the LLM
(* Enter RETURN for record
(* Suggested interrupt level
(* Increase this value for rates
less than 9600 bps
LABEL OF COMMON INT ROUTINE: IDLOOO
LABEL OF UNSOLICITED INT ROUTINE: IDLINT
EXTENSION DATA: !DATA 0,0,0 (* DSR scratch space
EXTENSION DATA: (* Enter RETURN to continue
DEVICE NAME: DLOG
DEV TYPE: SD
TILINE DEVICE? (NO)
CRU BASE ADDR: 0
ACCESS MODE:
INT LEVEL IN MAIN CHASSIS: 15
TIME-OUT COUNT:
CRU !NT BIT: (15)
LABEL OF DSR: DUMLOG
(* Specifies REMSCI without OCP
(* Based on system configuration
(* Entry required to continue,
interrupt not used
(* Time-out ignored by dummy DSR
(* Entry required to continue
LABEL OF COMMON INT ROUTINE: DUMIDL
LABEL OF UNSOLICITED INT ROUTINE: DUMRT
EXTENSION DATA: {* No extension data required
'DEVICE NAME: (* No more associated devices
SVC
# -
XOP -
Figure C-l
(* No special SVCs required
(* No special XOPs required
Generating a TX5 System (Sheet 1 of 2)
C-4 2270526-9701