Texas Instruments 990 User Manual page 153

Appl i ca t ions U ti 1 i ti es
5.4.3.5 Display Error Codes (ERRS)Canmand ••
The ERRS command displays the error oodes used by the HOLC
software package. When the command is entered while remote
SCI
is acti
ve,
the followi ng prompt appears:
<> ERRS
DISP LAY ERroR CODE S FOR TYP ES: S VC, UL, AS, WT, PK, LC
ERROR TYPES: SVC (example response)
The response to the ERroR TYPES prompt must
be
one of the options
di spl ayed • Thi s res ul ts in the di spl ay of a fil e cont ai ni ng
error code information for one of the following error types:
* SVC. Error codes ret urned by the SVC >4 D processor when
an application task makes read, write, or activation
s er vi ces calls
*
UL. Upper-level protocol error codes
*
AS. Acti vation services error codes
*
WI'.
Warm-start/timer error codes
*
PK. Packet-level error codes
*
LC. Link control error codes
Refer to Section 4 for an explanation of the SVC error oodes;
refer to Appendix A for explanations of the others.
5 • 4. 3. 6 I ni ti al i ze D at e and Time ( I Dr) C anm and.
The IDr command initializes the date and time in the specified
secondary station by transmitting the date and time in the
DXIO.
The prompts and example resp::>nses for the command are:
<> lor
REIDTE INITIALIZE mTE AND TIME
SECDNDARY ID: 1002 (example resp::>nse)
Enter the network ID assigned to the remote
SCI
task in the
desired secondary station in response to the SECDNmRY ID prompt.
2270526-9701
5-31