Texas Instruments 990 User Manual page 200

Appl icati ons U t i l i ti es
thi s fi 1 e is • IN1l3 CDMM. CJ3 JE cr. ARI' mT.
c. TAS KID. Thi s m us t be >1 O. A network ID also
must have been assi gned during network
generation.
d • PRIORITY.
through
3.
This value must be in the range of
1
A hi gher val ue increas es throughput.
e. PRIV ILE GE D.
pr i viI eged •
Answer NO, this task is
not
3. After the task is installed, i t must be executed using
the remote SCI oommand XT
as
follows:
<>
XT
REMJTE EXECUTE TASK
SECDNDARY ID: 0200
TASK ID: >10
PARM 1: 0
PARM 2: 0
(e xam pI e res };X)ns es )
Enter resp:>nses to the above prompts as follows:
a.
SECDNDARY ID. Enter the network
ID. of
the
s econdar y st ati on •
b. TASK ID. Enter the I D of the task just
installed •
c. PARM 1 and PARM 2. Take the def aul ts for thes e
prompts.
When the task is installed and executed in the secondary station,
the ar t i fi ci al dat a progr am is ready to process dat a.
To send a message to the secondary station enter AE, AR, or AD in
res};X)nse to the ENrER REQJEST prompt (on the statistics menu).
The following display appears in resp:>nse to any of the three
commands:
STAT I CN I D ( 01 00 -9 999): 022 0
TASK I D ( 01 00 -9 999): 022 5
MESSAGE COUNT (20 - 50): 50
MESSAGE LENGI'H (1 - 256): 100
TASK PRIORITY: 1
USE AcrIVATICN SEWICES?: NO
LIS TING ACCESS
NAME: LPO
2
(example
res p:>ns es )
Enter resp:>nses to the above prompts as follows:
*
STATICN ID. Enter the network ID of the TX5 station.
5-78
22 7052 6 -9 701