Texas Instruments 990 User Manual page 155

Appl ications U til i ti es
5 • 4. 3. 8 Kill T as k (K T) C anm and •
The KT command term inates the execution of a speci fi ed tas kin a
specified secondary station. The prompts and example responses
for the command are as follows:
<>
KT
REIDTE KILL TASK
SECDNDARY I D: 1012
TASK ID: >2B
(example
res p::>ns es )
The resp:>nses must conform to the following requirements:
*
SEffiNDARY ID. Enter the network I D assigned to the
*
remote SCI task in the desi red secondary station.
TASK ID. Enter the hexadecimal number assigned
t as k at the tim e of T X5 s ys t em ge ne r at ion.
to
the
5.4.3.9 List Breakpoints
(IE)
Canmand.
The LB command causes all breakpoints assigned in a specified
secondary task to be displayed on the interactive terminal where
the command was entered. The prompts and example resp::>nses for
the command are as follows:
<>
IB
REM)TE LIST BREAKPOINTS
SECDNDARY I D: 1021
TASK ID: >3D
(example
responses)
The res pons es must conform to the followi ng requi rements:
*
SEffiNDARY ID. Enter the network ID assigned to the
remote SCI task in the desired secondary.
*
TASK ID. Enter the hexadecimal num her assi gned to the
t as k at the time of TX5 system generation.
Alternati vel y, the def aul t can be taken. If the def aul t
is taken, all breakpoints in the secondary station are
displayed. If
S
is entered, only the system breakpoints
appear.
2270526-9701
5-33