(Config: Remote) Ethernet Snmp; (Config: Remote) Ethernet Snmp Community Traps; Config:) Tx; (Config: Tx) Fec - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710 Broadcast Satellite Modem
Front Panel Operation
(CONFIG: Remote) Ethernet
SNMP Trap IP Address:
IP1
Select IP1, IP2, or Version using the
(CONFIG: Remote) Ethernet
To edit the SNMP Trap IP#1 or IP#2 Address, first use the
the digit to be edited, then use the
Press
(CONFIG: Remote) Ethernet
Select SNMPv1 or SNMPv2 using the
5.3.1.2

(CONFIG:) Tx

The Scram(bler) selection only appears if the Mode selection is DVB-S2.
IMPORTANT
Tx: FEC
Mode Freq Pwr Scram (
Select FEC, Mod, Code, SymRate, Mode, Freq, Pwr, or Scram using the
then press
ENTER

(CONFIG: Tx) FEC

Tx FEC:
Viterbi + Reed-Solomon (
This screen is 'status only' and its appearance depends on the selection made under the
(CONFIG:) Tx
For DVB-S2 Mode only:
IP2 Version
IP1, IP2
Trap ID #X:
000.000.000.000
when done.
ENTER
Version
Trap Version:
SNMPv1 SNMPv2
Mod Code SymRate
.
Mode menu.
SNMP
arrow keys, then press
SNMP
( E )
arrow keys to change the value of that digit.
SNMP
( E )
arrow keys, then press
E)
E)
5–11
Revision 11
MN/CDM710.IOM
Community Traps
.
ENTER
Community Traps
arrow keys to select
Community Traps
.
ENTER
arrow keys,