CCR Key: 2 Tr: 1
CHNG
DISABL
OK
CCR Key:
RETRY
OK
CCR Key: x
CHNG
NEXT
CCR tree:
RETRY
OK
CCR Key: x Tr: x
CHNG
DISABL
OK
Type: Norm
Force
XFER
OK
Another step?
YES
QUIT
If you want to continue to add steps to the table:
•
To add a Distribute for step, start at step 10 of
•
To add a Goto for step, start at step 10 of
•
To add a Transfer step, start at step 10 of
•
To add a Disconnect step, start at step 10 of
Note: You can add steps to a routing table only when you set it up. After you set up the
table, you cannot add or delete steps. You can only modify the steps that you created. If
you have set up a routing table and you want to add or remove steps, you must erase the
table and create it again.
23 The display shows the default key for a CCR Tree.
Press CHNG if you want to change the key that callers press to reach
the CCR Tree
or
press DISABL if you do not want callers to be able to press a key to
reach the skillset mailbox, press NEXT and go to step 29
or
press OK to accept the default key and go to step 29.
Note: You cannot let callers transfer to a CCR Tree unless you
have created a CCR Tree. Refer to the CallPilot Telephone
Administration Guide or the CallPilot Manager Set Up and
Operation Guide.
24 Enter the key you want to assign for the CCR Tree and press OK.
25 Press NEXT.
26 Enter the number of the CCR Tree you want callers to transfer to
and press OK.
27 Press OK.
28 Press OK.
29 Press YES to continue to build the table
or
press ® to end the session.
"Adding a Goto step" on page
"Adding a Transfer step" on page
"Adding a Disconnect step" on page
CallPilot 100/150 Basic Call Center Telephone Administration Guide
Chapter 9 Routing table administration
"Adding a Distribute for step" on page
109
110.
111.
112.
114.